First, Install A Hard Disk And Connect The Sc101; Verify The Hard Disk Is Set To "Cable Select - NETGEAR SC101 Reference Manual

Reference Manual for the NETGEAR Storage Central SC101
Unpack the unit, Ethernet cable, power adapter, and the NETGEAR CD. The CD contains driver
software, a setup wizard, and links to online resources. Familiarize yourself with the SC101 unit.
Notice the rear of the SC101 has information about the ports and the front status lights.
Note: When you set up the unit, stand it on its feet, and be sure it has ample ventilation.
Avoid putting the unit in a location where it could be knocked over easily. Do not place
items on top of it.

First, Install a Hard Disk and Connect the SC101

The instructions below explain how to set up a single disk. Repeat these steps to install a second
hard disk.

Verify the Hard Disk Is Set to "Cable Select"

The drive jumpers must be set for the "cable select" option, marked "CS" on some drives.
Typically, this is the default setting. Follow these steps to verify that the hard disk drive is set to
"cable select."
1. Locate the hard disk jumpers.
2. Verify that the jumpers are set to "cable
select."
The disk housing or documentation will identify
which setting is "cable select."
Note: The setting for your drive may differ from
this illustratoin. Be sure to consult the
documentation provided by the hard disk
manufacturer or look on the hard disk to
identify which setting is "cable select."
3-2
Figure 3-3
v1.0, September 2005