Control Panel; Positioning The Control Panel; Control Panel Overview - Honeywell Friedland GlobalGuard HISK1 Hardware Installation And Operating Manual

CONTROL PANEL

Note that to fully install the Control Panel in
position, the siren's battery charging
process must be complete. If it has not yet
completed then you should prepare
mounting the Control Panel's mounting
bracket in position as described below.

POSITIONING THE CONTROL PANEL

When choosing a suitable location for the
Control Panel, the following points should be
considered.
1. The Control Panel should be located in a
position out of sight of potential intruders
and in a safe location, but easily accessible
for system operation and leaving and
entering the house within the set time
period.
2. The Control Panel should be mounted on a
sound flat surface to ensure that the rear
tamper switch on the Control Panel is
closed when the Panel is mounted. The
Control Panel should be mounted at a
convenient height of between 1.5 and 2
metres and in a position where it will be
seen each day.
Note: If small children are in the household,
further consideration should be given to
keeping the unit out of their reach.
3. It is recommended that the Control Panel
should be positioned such that the
Exit/Entry tone (emitted by the Control
Panel) can be heard from outside the
property.
4. The Control Panel should be mounted
within a protected area so that any intruder
cannot reach the Control Panel without
opening a protected door or passing
through an area protected by a PIR
Detector when the system is armed.
5. The Control Panel must be located
within reach of a mains socket.
6. DO NOT fix the Control Panel onto or
very close to metalwork (i.e. radiators,
water pipes, etc) as this could affect the
radio range of the device.

CONTROL PANEL OVERVIEW

LCD Display
The LEDs indicate the following status:
On Steadily
AC power in
use
System is
Fully/holiday
armed
System
message
Panic button
is pressed
Function/Programme
activation keys
LED Indicators
Flash Off
Battery in use /
Flash slowly: -----
Low battery
System is set System
in Part-Arm-I/II disarmed
Alarm memory Normal
----- Normal
Panic Button
16