Install Batteries; Replace Batteries - Honeywell 2512 User Manual

INSTALL BATTERIES

The batteries must be installed before using your safe.
1. Remove the battery compartment
cover located on the right side of
the control panel by pushing in
and to the right.
2. Insert 4 "AA" batteries. Ensure the
batteries are installed in the
correct direction, with regard to
polarity (+ and -).
3. If the batteries are put in correctly,
the safe will beep and the LCD
readout will flash, then it will read
"GOOD"
4. Once the batteries are properly
installed, replace the battery
compartment cover.

REPLACE BATTERIES

Weak or dead batteries should be
replaced immediately and all 4
batteries should be changed. To replace
the batteries, please follow the
instructions in STEP 1. in the "INSTALL
BATTERIES" section. Remember to
always remove batteries from safe if not
using for an extended period of time. If
your batteries are completely dead and
you cannot open the safe by using the
digital keypad, use the override access
key to open safe.
NOTE: It is NOT RECOMMENDED to use
Non-alkaline or rechargeable batteries.
If the batteries are removed or fail, the keypad memory will NOT be erased
and the active programmed code will still work once power has been restored.
1.
2.
3.
4.
4