Override Access Key / Install Batteries - Honeywell 5605 User Manual

OVERRIDE ACCESS KEY
Your safe is equipped with an override access key which allows immediate access
in case you forget your user codes or the batteries need to be installed or replaced.
1. Remove override key cover with small screwdriver (Figure 1).
2. Insert the override access key into the lock until it stops (Figure 2).
3. With the key inserted turn counter clockwise to the left (Figure 3).
4. Turn knob clockwise to the right and pull safe door open (Figure 4).
Figure 1
5. Remove override access key and store it in a safe place away from the
safe. Replace the cover over the key lock and proceed to "Install Batteries".
INSTALL BATTERIES
The batteries must be installed before using your safe. The battery compartment is located inside
the safe on the lock cover panel.
1. Remove battery compartment cover and insert 4 "AA" batteries. Make sure that the
batteries are installed in the correct direction with regard to polarity (+ and -).
(Figure 1 & Figure 2).
2. Replace the battery cover (Figure 3).
3. Proceed to the "Testing Digital Lock" section on next page.
Figure 1
Note:
If both green and red LED's are on, it is an indicator that the batteries are weak and must be
changed immediately. The User Code will not be erased if power is restored by replacing the
batteries within 30 minutes. After 30 minutes, the User Code will be erased and will need to be
reprogrammed. Weak or dead batteries should be replaced immediately and all 4 batteries should
be changed. To replace the batteries please follow STEPS 1 - 3. Remember to always remove
batteries from safe if not using for an extended period of time. If your batteries are completely dead
and you cannot open the safe by using the digital keypad, use the override access key to open safe
and access the battery compartment. The use of Non-alkaline or rechargeable batteries is NOT
RECOMMENDED.
Figure 2
Figure 2
Figure 3
Figure 3
2
Figure 4