Getting Started; Obtaining Connectivity To The Hp Msr Sbm; Accessing The Hp Msr Sbm On Its Domain Name - HP JG587A Quick Start Manual

Getting started

Before installing and using the HP MSR SBM, make sure the network to
which it will access is available, and the domain manager, DNS server,
and Lync server are successfully installed.

Obtaining connectivity to the HP MSR SBM

The HP MSR SBM products have no default management IP addresses
when they are shipped. Therefore, after installing the OAP module,
obtain connectivity to the HP MSR SBM's management interface, and
then you can access the HP MSR SBM and install the system by using the
Setup Wizard.
You have two choices for reaching the HP MSR SBM: on its domain name
or IP address.

Accessing the HP MSR SBM on its domain name

If the DHCP and DNS servers are successfully installed, HP recommends
that you contact the HP MSR SBM at an FQDN in your domain. The serial
number of the HP MSR Survivable Branch Communication Module (SBM)
powered by Microsoft Lync™ is the initial domain name that you can use
to access the HP MSR SBM. The serial number is posted on the front
panel of the card, as shown in the following figure. The serial number is
a string containing ten characters, which may include letters and
numbers, as shown in the figure below:
9