Figure 4-6 Ip Configuration - NETGEAR GSM712 Installation Manual

15. On the Set Up page, hit the 'B' key to select the IP Configuration page.

Figure 4-6 IP Configuration

16. On the IP Configuration page, type in the desired IP Address for this switch, followed by the 'Enter' key.
Note: this switch is not DHCP client capable. You must assign a static IP address to the switch.
17. Now type in the desired Network Mask, followed by the 'Enter' key.
18. Now type in the desired Default Gateway, followed by the 'Enter' key.
19. Use Ctrl-W to save these new settings. Hit the 'Y' key or 'Enter' to confirm saving the new settings to NVRAM.
The switch will now reset, loading the new IP address. At this point you can use your web browser to manage your switch through the network.
After you have connected your computer to the switch via one of the network ports, simply launch your web browser and type the IP address in the
Address Bar to use the Graphical User Interface (GUI) for configuration, observation, and management of your switch.
Page 20 of 105