Figure 6-10: Restore Factory Values - NETGEAR GSM712 Installation Manual

Main Menu> Tools> Save Configuration
After making any changes to the screens within the console interface, users must save the changed settings to NVRAM.
Save Configuration to NVRAM
Select Save Configuration and then use either 'Enter' or 'Y' to save the configuration to NVRAM.
Restore Factory Values
Select Restore Factory Values to reset the switch parameters to their original default settings. In order for changes to take effect, you must Reset
the switch.
Note: network IP settings (i.e. IP address, Gateway Address, Network Mask) will not be affected by this command.

Figure 6-10: Restore Factory Values

Page 35 of 105