NETGEAR RO318 Reference Manual page 66

Reference Guide for the Model RO318 Cable/DSL Security Router
The System Status screen shows the parameters listed in
Table 6-1. System Status fields
Field
System Name
Router Firmware Version
WAN Port
IP Address
IP Subnet Mask
DHCP
LAN Port
IP Address
IP Subnet Mask
DHCP
6-2
Description
This field displays the Host Name assigned to the router.
This field displays the router firmware version.
These parameters apply to the Internet (WAN) port of the router.
This field displays the IP address being used by the Internet (WAN) port
of the router. If no address is shown, the router cannot connect to the
Internet.
This field displays the IP Subnet Mask being used by the Internet (WAN)
port of the router.
If set to None, the router is configured to use a fixed IP address on the
WAN or to use PPPoE.
If set to Client, the router is configured to obtain an IP address
dynamically from the ISP.
These parameters apply to the Local (WAN) port of the router.
This field displays the IP address being used by the Local (LAN) port of
the router. The default is 192.168.0.1
This field displays the IP Subnet Mask being used by the Local (LAN)
port of the router. The default is 255.255.255.0
If set to None, the router will not assign IP addresses to local PCs on the
LAN.
If set to Server, the router is configured to assign IP addresses to local
PCs on the LAN.
Table 6-1
Maintenance