Toro Revolution Series Operator's Manual page 20

Lowering the Roll Bar
Important:
Lower the roll bar only when
absolutely necessary.
1. For both sides of the roll bar, remove the hairpin
cotter and pin.
2. Lower the roll bar to the down position.
Note:
There are 2 down positions, as shown
in Figure 19.
3. Install the 2 pins and secure them with the
hairpin cotters.
Figure 18
Figure 19
1. Down position with the
bagger installed
g399200
g399199
2. Full down position
Raising the Roll Bar
Important:
Always use the seat belt with the roll
bar in the raised position.
1. Remove the hairpin cotters and remove the 2
pins.
2. Raise the roll bar to the upright position.
3. Install the 2 pins, and secure them with the
hairpin cotters.
20
Figure 20
g399201