Service And Adjustments - Ariens Razor Owner's/Operator's Manual

CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE POSITION
Put unit into service position for easy access
to bottom of deck.
CAUTION: Avoid fuel spills. Follow
steps below to help prevent fuel
spills. If fuel leaks into air cleaner,
replace air cleaner. ALWAYS clean
up any spilled fuel.
1. Place unit on a flat, level surface.
2. Disconnect spark plug wire.
3. Remove fuel cap.
4. Place a piece of plastic bag over the
opening and tighten cap securely.
5. Tip unit onto right side.
Make sure unit is secure and will not tip
over.
IMPORTANT: Remove plastic from fuel cap
after unit is upright and service is complete.
HANDLEBAR HEIGHT
(Model 911373)
To adjust (Figure 13):
1. Remove hardware from lower handlebar
mounting hole.
2. Rotate the handlebar to the desired
position and align the mounting holes
with the holes in the handlebar upright.
3. Secure handlebar with hardware
removed in step 1.
NOTICE: To fold handlebar flat for storage,
remove the hardware from the lower
handlebar mounting holes, rotate the
handlebar forward, and then tighten the
hardware in the holes on the handlebar. See
Figure 15.

SERVICE AND ADJUSTMENTS

1. Handlebar
2. Mounting Hardware
HANDLEBAR HEIGHT
(Models 911375, 379)
To adjust (Figure 14):
1. Push the operator presence control
handle forward and rotate handlebar to
the desired position.
1. Operator Presence Control Handle
To store (Figure 15):
1. Push the operator presence control
handle forward and rotate handlebar to
desired position.
EN - 22
2
1
Figure 13
1
Figure 14