Service & Adjustments - Ariens Power Brush 28 Manual

Casters
IMPORTANT: Wipe each lube fitting clean
before and after lubrication.
1. Grease fittings on left and right side
caster shafts.
Drive
IMPORTANT: Wipe each lube fitting clean
before and after lubrication. DO NOT allow
grease or oil to get on the friction disc, drive
disc or belts.
NOTE: Apply Ariens Hi-Temp Grease (Ariens
p/n )or equivalent to the lube fittings
(Figure 12).
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before
proceeding.
RECOIL GUARD FOAM COVER
INSTALLATION
The recoil foam cover slides over the starter
handle and attaches to the recoil guard with
Velcro. See Figure 13.
NOTE: The recoil guard foam cover is not
necessary for operation during the non-winter
months.
IMPORTANT: When using the unit in the
winter months the cover must be installed.
The foam prevents snow from getting into the
recoil guard and freezing the recoil pawls.
IMPORTANT: Be sure to keep the recoil foam
cover clean and clear of snow and debris at
all times. See Clean Recoil Guard Foam
Cover on page 17.
SERVICE AND ADJUSTMENTS
Grease
Oil
Recoil Guard
Foam Cover
GB - 18
Figure 12
Velcro
Recoil Guard
Figure 13
OS7245