Table of Contents
Advertisement
Drive
IMPORTANT: Wipe each lube fitting clean
before and after lubrication. DO NOT allow
grease or oil to get on the friction disc, drive
disc or belts.
NOTE: Apply Stens Mix Hi-Temp Grease or
equivalent to the lube fittings (Figure 8).
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SPEED SELECTOR ADJUSTMENT
1. Place unit into service position.
2. Remove hair pin from adjustment pivot
pin (Figure 9).
3. Pull shift rod and pin out of speed
selector lever.
4. Place the speed selector in the fastest
reverse speed position.
5. Pull the shift rod straight up towards the
control panel as far as it will go.
6. Thread the adjustment pivot pin along the
shift rod until it aligns with the mating hole
on the speed selector lever. Insert the
pivot pin into hole.
7. Make sure the speed selector shifts into
each speed position.
8. Secure adjustment pivot pin with hairpin.
SERVICE AND ADJUSTMENTS
6
5
4
1.Shift Arm
2.Shift Lever Arm
and Bracket
3.Axle Shaft
Grease
5
1.Shift Rod
2.Adjustment Pivot
Pin
3.Speed Selector
Lever
ATTACHMENT CLUTCH
ADJUSTMENT
(Figures 10 and 11)
1. Remove belt cover.
2. Check belt alignment (Figure 11).
Engine sheave and attachment pulley
must align vertically. Also, belt must be
centered in the idler pulley.
To align, move attachment pulley:
a.Loosen set screws.
GB - 17
1
4.Sprocket/Pinion
Assembly
5.Hex Shaft
6.Pinion Chain
Oil
Figure 8
3
OS0021
1
4.Hairpin
5.Speed Selector
Position
Figure 9
2
3
OS0743
2
4
OSs0193
Advertisement
Table of Contents
