Ariens Razor Owner's/Operator's Manual page 23

WARNING: DO NOT operate unit
with handlebar in storage position.
Handlebar must be in operating
position before using.
2
1. Operating Positions
2. Storage Positions
Figure 15
DRIVE BELT REPLACEMENT
(Models 911375, 379)
To Remove Drive Belt:
1. Disconnect spark plug wire.
2. Move cable adjuster to loosen wheel
drive cable.
3. Disconnect the drive cable spring from
the transmission bracket. See Figure 16.
1
2
1. Drive Cable Spring
2. Transmission Bracket
1
Figure 16
4. Remove blade and blade adapter from
the crankshaft.
5. Remove drive pulley guide, belt channel
guides and engine pulley with key.
6. Pull belt over end of crankshaft to allow
belt to slide out through belt channel.
7. Rotate transmission backward to
remove hardware, then adjust to loosen
belt.
8. Remove belt and pull through the belt
channel. See Figure 17.
EN - 23