Ariens Razor Owner's/Operator's Manual page 24

1
2
5 9 8
11
1. Blade
2. Blade Adapter
3. Drive Pulley Guide
4. Belt Channel Guides
5. Engine Pulley with Key
6. Transmission
7. Transmission Bracket
8. Belt
9. Belt Channel
10. Transmission Pulley
11. Crankshaft
Figure 17
3
4
6
7
Install Drive Belt
See Figure 17.
1. Route new belt through belt channel.
2. Route belt around transmission pulley
and reinstall transmission bracket and
hardware. Rotate transmission back into
location. Loop belt over crankshaft end.
Install engine pulley with key.
3. Install belt channel guides and drive
pulley guide.
4. Install blade adapter and blade. Make
sure the blade hardware is tightened to
the proper torque. See To install blade:
on page 20.
5. Connect the wheel drive cable spring to
the transmission bracket and rotate drive
cable adjuster to properly adjust drive
cable See ADJUST WHEEL DRIVE
CONTROL on page 25. See Figure 16.
6. Connect spark plug wire.
10
OPERATOR PRESENCE
CONTROL (OPC) HANDLE
ADJUSTMENT
NOTICE: The operator presence control
handle has no user serviceable adjustments.
If releasing the handle does not stop the
engine or blade within 3 seconds, take the
unit to an authorized Ariens dealer for repairs.
EN - 24