Table of Contents
Advertisement
NOTICE
To avoid the possibility of malfunction/ damage to the product,
damage to data, or damage to other property, follow the notices
below.
Handling and maintenance
• Do not use the product in the vicinity of a TV, radio, or other
electric products. Otherwise, the product, TV, or radio may
generate noise.
• Do not expose the product to excessive dust or vibration, or
extreme cold or heat, in order to prevent the possibility of
panel disfiguration, unstable operation, or damage to the
internal components.
• Do not install in locations where temperature changes are
severe. Otherwise, condensation may form on the inside or the
surface of the product, causing it to break.
• If there is reason to believe that condensation might have
occurred, leave the product for several hours without turning
on the power until the condensation has completely dried out,
in order to prevent possible damage.
• This product is designed to be transported in the Yamaha
CASE-STP 200 speaker carrying case. If you use other devices to
carry this product, it may become unstable, causing it to
malfunction.
• Do not use sodium hypochlorite solution, ethanol, benzine,
thinner, detergent or a chemical rag to clean the surface of the
product. Otherwise, the surface may become discolored or
deteriorate.
Handling and maintenance for Battery
• This product is a lithium-ion battery. Charge this product
before using it. Even if you plan not to use this product for a
long period of time, recharge it every six months to maintain
battery power. Otherwise, the product may become unable to
retain a charge.
• If you plan not to use this product for a long period of time,
remove the battery from the relevant device. Otherwise, the
batteries may be drained, or battery liquid may leak, possibly
resulting in damage to your device.
• Do not remove the batteries from its original packaging until
required for use.
• Keep the batteries clean and dry.
• Wipe the battery terminals with a clean dry cloth if they
become dirty.
• Do not leave the batteries on prolonged charge when not in
use.
• If you plan not to use this product for a long period of time,
remove the battery from the relevant device. Otherwise, the
battery may be drained, or battery liquid may leak, possibly
resulting in damage to your device.
• Do not install this product in a place subject to drastic changes
in ambient temperature. Otherwise, condensation may form
inside and on the surface of your device, resulting in damage to
the device.
• If there is a reason to believe that condensation might have
occurred on or in the device, leave it for a while, and then turn
on the power to the device. Turning the power on while
condensation is present may cause damage to the device.
• Charge the battery under an ambient temperature in the range
of 0°C to 40°C.
8
STAGEPAS 200BTR STAGEPAS 200 Owner's Manual
The Bluetooth® word mark and logos are registered trademarks
owned by Bluetooth SIG, Inc. and any use of such marks by
Yamaha Corporation is under license.
The model number, serial number, power requirements, etc., may be
found on or near the name plate, which is at the rear of the unit. You
should note this serial number in the space provided below and
retain this manual as a permanent record of your purchase to aid
identification in the event of theft.
Model No.
Serial No.
Information
About functions/data bundled with the product
• Even when the [P] (Standby/On) switch is in standby status,
electricity is still flowing to the product at the minimum level.
When you are not using the product for a long time, make sure
you unplug the power cord from the wall AC outlet.
• XLR-type connectors are wired as follows (IEC60268 standard):
pin 1: ground, pin 2: hot (+), and pin 3: cold (-).
About this manual
• The illustrations and screens as shown in this manual are for
instructional purposes only.
• The company names and product names in this manual are the
trademarks or registered trademarks of their respective
companies.
• Software may be revised and updated without prior notice.
About disposal
• This product contains recyclable components.
When disposing of this product, please contact the appropriate
local authorities.
WARNING
Do not dispose your old battery in the trash. Call 1-877-2-
RECYCLE, to find a retail collection site nearest you to recycle your
battery. You can also locate a collection site on the Rechargeable
Battery Recycling Corporation (RBRC) website at;
http://www.call2recycle.org/
When this product has reached the end of its life, please remove
and recycle the battery before you dispose of this product.
PLEASE NOTE: The above wording is only for; Nickel Cadmium
(Ni-Cd), Nickel Metal Hydride (Ni-MH), Lithium Ion (Li-ion) and
Small Sealed Lead (Pb) batteries.
Yamaha cannot be held responsible for damage caused by
improper use or modifications to the product, or data that is
lost or destroyed.
PA_en_12 3/3
(1003-M06 plate rear en 01)
Advertisement
Table of Contents
