Troubleshooting - Yamaha STAGEPAS 200 Owner's Manual

Troubleshooting

Symptoms Possible causes
Power does not turn You did not firmly and securely connect the power cord.
on.
If the unit is running on the battery, the battery charge
level is not sufficient.
Power shuts down The vents on the unit are blocked. Since inadequate
suddenly. ventilation can result in overheating inside this product,
the power may be turned off automatically to protect
the system from overheating.
The unit will engage standby mode if the Auto Standby
function is enabled and no audio has been input for at
least 30 minutes.
No sound is heard. If the [P] (Standby/On) indicator is flashing rapidly, it
indicates that the internal power amplifier is overloaded,
and the amplifier is muted to protect its circuits.
Sound is distorted. The [LEVEL] controls of any relevant channels and/or the
Noise is produced. MAIN [LEVEL] control are set too high.
The [MIC, LINE/LINK] switch or [MIC, LINE] switch is set to
the MIC position. If the input level from the source is
high, setting the relevant switch to the MIC position may
result in a distorted sound.
The volume level of the external device connected to
the mixer is too high.
Sound is not loud The [LEVEL] controls of any relevant channels and/or the
enough. MAIN [LEVEL] control are set too low.
The [MIC, LINE/LINK] switch or [MIC, LINE] switch is set to
the LINE position.
The volume level of the external device connected to
the mixer is too low.
Some settings can be controlled only from STAGEPAS
Controller.
The high-range You turned the [EQ/PRESET] control clockwise or
sounds and low- counter-clockwise too much.
range sounds are
unbalanced.
[
Cannot connect If the
Bluetooth. unit is connected to a different Bluetooth device.
Pairing failed. In particular, the initialization process will
wipe off the pairing information.
Bluetooth audio The unit may be located in the vicinity of a device that
sound cuts emits electro-magnetic waves at a frequency of 2.4 GHz
intermittently. (such as a wireless microphone transmitter, wireless LAN
device, microwave oven, etc.).
The wireless LAN function on the Bluetooth device is
enabled.
The [ ] (Charge) Battery has abnormality.
indicator is flashing
rapidly.
If a problem persists, please contact your Yamaha dealer.
] (Bluetooth) indicator is lit, it means that the
Action to take
Connect the power cord firmly and securely.
Plug in this product to an AC outlet with the power cord
to charge the battery.
Arrange the ventilation for better cooling, then turn the
power on again.
Press the [P] (Standby/On) switch.
Leave the unit in a cool place for a while. The amplifier
will automatically reset itself.
Turn the relevant [LEVEL] control to the minimum (zero),
then set the switch to the LINE/ LINK or LINE position,
and then slowly raise the [LEVEL] control.
Set the switch to the LINE/LINK or LINE position.
Lower the volume level of the external device.
Turn the relevant [LEVEL] control to the minimum (zero),
then set the switch to the MIC position, and then slowly
raise the [LEVEL] control.
Set the switch to the MIC position.
Raise the volume level of the external device.
Use STAGEPAS Controller to adjust the settings, or
initialize the unit.
Set the [EQ/PRESET] control to the center (FLAT)
position.
Cut the current Bluetooth connection, and then connect
to the desired Bluetooth device.
Pair the device again.
Locate the unit away from any device that emits electro-
magnetic waves.
Turn off the wireless LAN function, and enable only the
Bluetooth function.
Stop using the unit immediately, remove the battery
from the unit, and then contact your Yamaha dealer.
STAGEPAS 200BTR STAGEPAS 200 Owner's Manual
23