Yamaha STAGEPAS 200 Owner's Manual page 10

[EQ] controls (channels 1-3, channel 4/5)
%
From the center (FLAT) position, turn these controls
counter-clockwise to cut the low range. Turn them
clockwise to boost both low and high ranges.
[PRESET] controls
Turn them in either direction beyond the EQ setting area
(labeled by solid lines) to select a preset setting. The
Comp and Mic Simulator functions are available.
Channel 1 is suitable for connecting a microphone or a
keyboard.
Channels 2 and 3 are suitable for connecting a
microphone or a guitar.
Channel 4/5 is suitable for connecting a music player or a
keyboard.
^ [EFFECT] controls (channels 1–3)
Determine the effect type and send amount.
Select the effect type from the following options (reverb,
or a combination of reverb and delay and/or chorus).
• R: Reverb
• R+D: Reverb + Delay
• R+C: Reverb + Chorus
• R+D+C: Reverb + Delay + Chorus
Each " " mark labeled around the controls refers to the
Send amount. As you turn the controls clockwise within
each effect type range, the Send amount will increase.
[PHANTOM CH1-3] switch
&
Press this switch to supply phantom power only to the
XLR connectors of the INPUT [1/LINK], [2], and [3] jacks.
NOTICE
If you do not need to use phantom power, turn this switch
off.
Before turning phantom power on, follow the precautions
below to avoid malfunction or noise of this product or
external devices.
• Turn this switch off if you are planning to connect a device
that does not support phantom power to the XLR
connector of the INPUT [1/LINK], [2], or [3] jack.
Alternatively, connect such a device using a phone plug
cable.
• While this switch is on, do not connect or disconnect a
cable from the INPUT [1/LINK], [2], or [3] jack.
• Before turning the phantom switch on or off, be sure to set
the [LEVEL] controls to the minimum level.
STAGEPAS 200BTR STAGEPAS 200 Owner's Manual
11