Table of Contents
Advertisement
USING EXTERNAL UNITS
To the line output jack
RESETTING THE MICROCOMPUTER
POWER
ON/
STAND-BY
TRANSPORTING THE UNIT
POWER
ON/
STAND-BY
CD
Video/Auxiliary (Audio signal) input
To listen to or record signals from external sources
through this unit:
1
Use a separately available RCA cord to connect the desired
external unit to the VIDEO/AUX jacks.
(red → right channel, white → left channel)
When using video equipment (Laser Disc player or VCR), be
sure to connect the audio output to this unit and the video
output to a television.
RCA
2
Press the ON/STAND-BY button to turn the power on.
cord
3
Press the VIDEO/AUX button.
4
Operate the external unit.
5
To record the sound from the external unit, perform steps 2
- 4 of the "Recording from the built-in radio" section on page
13.
Note:
To prevent hum interference, do not place this unit near a
television receiver.
Headphones
Before plugging in or unplugging the headphones, make sure
the volume level is reduced.
Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and are between 16 ohms and 50 ohms impedance.
The recommended impedance is 32 ohms.
When headphones are connected, the speakers are discon-
nected automatically. Adjust the VOLUME control for the
desired volume.
Reset the microcomputer under the following conditions:
X-BASS/
To erase all of the stored memory contents (clock and timer
DEMO
settings, and tuner and CD presets).
If the display is not correct.
If the operation is not correct.
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
While pressing down the
button, hold down the ON/STAND-BY button for at least 1
second.
"CLEAR AL" will appear.
Caution:
The operation explained above will erase all data stored in
memory including clock and timer settings, and tuner and CD
presets.
Before you move this product to a new location, proceed
OPEN/
as follows:
CLOSE
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button.
3
Press the OPEN/CLOSE button to open the disc tray.
Remove all CDs inserted in the unit.
4
Press the OPEN/CLOSE button to close the disc tray.
Make sure that "NO DISC" is displayed.
5
Press the ON/STAND-BY button to enter the stand-by mode,
and then unplug the AC power cord from the AC outlet.
15
button and the X-BASS/DEMO
0/R
Advertisement
Table of Contents
