Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Sharp SD-EX200
Summary of Contents for Sharp SD-EX200
- Page 1 1-BIT DIGITAL AUDIO SYSTEM MODEL SD-EX200 OPERATION MANUAL...
-
Page 2: Special Notes
SPECIAL NOTES SD-EX200 CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Explanation of Graphical Symbols: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage”... -
Page 3: Important Safety Instructions
Instruction Manual for replacement or resetting of protective device. If replacement of the plug is required, be sure the service technician has used a replacement plug specified by the manufacturer that has the same overload protection as the original plug. SD-EX200 0109... - Page 4 IMPORTANT SAFETY INSTRUCTIONS (continued) SD-EX200 Outdoor Antenna Grounding - If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges.
-
Page 5: Table Of Contents
Notes NERGY TAR® Program Information As an NERGY TAR® Partner, SHARP has determined that this product meets the NERGY TAR® guidelines for energy efficiency. NERGY TAR® is a U.S. registered mark. WHY PURCHASE NERGY PRODUCTS? Many Electrical/Electronic Products use energy both when they are on and when they are off. -
Page 6: Introduction
Introduction SD-EX200 Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. SD-EX200 1-Bit Digital Audio System consisting of SD-EX200 (main unit) and CP-EX200 (speaker system). -
Page 7: Precautions
SHARP will not be held responsible for any damage resulting from use of this unit with a voltage other than that which is specified. -
Page 8: Controls And Indicators
Controls and indicators SD-EX200 Front panel 1. CD Cover ..........16 2. -
Page 9: Speaker System
5. Speaker Terminals ........12 Speaker grilles are removable: Make sure nothing comes into contact with the speaker diaphragms when you remove the speaker grilles. SD-EX200 Reference page Reference page... - Page 10 Controls and indicators (continued) SD-EX200 Remote control 1. Remote Control Transmitter ....... . .11 2.
-
Page 11: Remote Control
The remote control can be used within the range shown below: Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy the battery termi- music. 15˚ Remote sensor 8" - 20' (0.2 m - 6 m) 15˚ SD-EX200... -
Page 12: System Connections
System connections SD-EX200 FM antenna Right speaker Bass Reflex Duct How to open side covers Open the right and left side covers to connect the system. Speaker connection AM loop antenna Make sure to unplug the AC power cord before connecting the speaker wires. -
Page 13: Antenna Connection
Unplug the AC power cord from the AC outlet if the unit will not be in use for a pro- longed period of time. Outdoor FM antenna Outdoor AM antenna 49 feet (15 m) 75 ohm coaxial cable 25 feet Ground wire (7.5 m) Ground rod FM antenna wire AM loop antenna wire AC power cord SD-EX200... -
Page 14: General Control
General control SD-EX200 To turn the power on Press the ON/STAND-BY button to turn the power on. If the power does not turn on, check the AC power cord is plugged in properly. After use: Press the ON/STAND-BY button to enter the power stand-by mode. -
Page 15: Setting The Clock
Perform "Setting the clock" from the beginning. To change the 12-hour or 24-hour display: 1. Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on page 27 for details.] 2. Perform "Setting the clock" from the beginning. SD-EX200... -
Page 16: Listening To A Cd
Listening to a CD SD-EX200 This system can also play audio CD-R and CD-RW discs, but cannot record. Some audio CD-R and CD-RW discs may not be playable due to the state of disc or the device that was used for recording. -
Page 17: Advanced Cd Playback
In this mode, no sound is heard. Therefore, you should refer to the time display. When you lift your finger, the unit will re-enter the pause mode. SD-EX200... -
Page 18: Repeat Or Random Play
Advanced CD Playback (continued) SD-EX200 Direct play By using the direct buttons, the desired tracks can be played. Press the direct buttons to select the desired track. The direct buttons will allow you to select and play any track from 1 to 10 automati- cally. -
Page 19: Programmed Play
CD to some other, the programmed selections will not be cleared. During program operation, random play is not possible. Programmed tracks will be erased if the unit is unplugged or a power failure occurs. Playback time SD-EX200 button. -
Page 20: Listening To The Radio
Listening to the radio SD-EX200 Manual or Auto tuning Press the ON/STAND-BY button to turn the power on. Press the TUNER (BAND) button repeatedly to select the desired frequency band. FM stereo FM monaural Press the TUNING ( or ) button to tune in to the desired station. -
Page 21: To Recall A Memorized Station
Station 11 - 40: press the " 10" button followed by the two-digit number. For example, to choose 28 1 Press the " 10" button. 2 Press the "2" button. 3 Press the "8" button. Preset channel Frequency and frequency band SD-EX200... -
Page 22: Timer And Sleep Operation
Timer and sleep operation SD-EX200 This may be operated only with the remote control. Timer playback: The unit turns on and plays the desired source (CD, tuner) at the preset time. Sleep operation: The radio and compact disc player can be turned off automatically. - Page 23 When performing timer playback using another unit connected to the AUX IN Timer Play Indicator jacks, select "AUX" in step 9. At this time, only this unit will be turned on or enter the power stand-by mode automatically. (Another unit will not be turned on or off.) SD-EX200...
-
Page 24: Radio
Timer and sleep operation (continued) SD-EX200 Sleep operation The radio and CD can be turned off automatically. Play back the desired sound source. Press the TIMER button. Within 10 seconds, press the CURSOR ( or ) button to select "SLEEP". -
Page 25: Enhancing Your System
Be sure your headphones have a 1/8" (3.5 mm) diameter plug and are between 16 ohms and 50 ohms impedance. The recommended impedance is 32 ohms. Plugging in the headphones disconnects the speakers automatically. Adjust the VCR, DVD etc. volume using the VOLUME buttons. SD-EX200 Headphones... -
Page 26: Troubleshooting Chart
Many potential problems can be resolved by the owner without calling a service tech- nician. If something is wrong with this product, check the following before calling your autho- rized SHARP dealer or service center. General Symptom "CLOCK" appears when the clock time is checked. - Page 27 Condensation can cause the unit to malfunction. If this happens, leave the power on with no disc in the unit until normal playback is possible (about 1 hour). Wipe off any condensation on the transmitter with a soft cloth before operating the unit. SD-EX200...
-
Page 28: Maintenance
Maintenance SD-EX200 Cleaning the CD pickup lens Poor performance during CD playback (skipping or jumping) can be caused by a dirty or contaminated CD laser pickup lens, in this case cleaning may be required. Clean the lens gently with a dry cotton swab taking care not to touch the lens with your fin- gers. -
Page 29: Specifications
Specifications As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. -
Page 30: Consumer Limited Warranty
In no event shall Sharp be liable, or in any way responsible, for any damages or defects in the Product which were caused by repairs or attempted repairs performed by anyone other than an authorized servicer. Nor shall Sharp be liable or in any way responsible for any incidental or consequential economic or property damage.