Sharp CP-BA200 Operation Manual page 5

(Continued)
Left speaker
1 3
2
FM antenna
1
2
Caution:
When the speaker grilles are removed, the speaker diaphragms
are exposed. Make sure nothing comes into contact with the
speaker diaphragms.
Fit the four posts on the speaker grille into the mounting holes
and push them lightly with the palm of your hand to secure.
Right speaker
The left and right speakers have individual shapes. For best per-
formance, place the speakers according to the diagram to the
left.
Connect the antenna wire to the ANTENNA jack.
FM antenna
Position the FM antenna wire in the direction where the strongest
signal can be received.
AM loop antenna
Position the AM loop antenna for optimum reception.
AM loop
Place the AM loop antenna on a shelf, etc., or attach it to a
antenna
stand or wall with screws (not supplied).
Notes:
AC 120 V, 60 Hz
To an AC outlet
Removing the speaker grilles
Remove the lower part of the speaker grille first.
Remove the upper part of the speaker grille.
Only the grills on the woofers are removable.
Mounting the speaker grilles
Placing the speaker system
Antenna connection
Do not place the antenna on the main unit as it may result in
noise pickup from the internal digital electronics.
Place the antenna away from the unit for better reception.
If the AM loop antenna and the FM antenna wire are placed
near the AC power cord, interference may result.
Do not connect the attached FM antenna to an outdoor FM
antenna. Otherwise, trouble may occur.
Connecting the AC power cord
After connecting the speakers, plug the AC power cord into a
convenient AC outlet.
Unplug the AC power cord from the AC outlet if the unit will
not be in used for a prolonged period of time.
4