Hart Mapping Parameters - Siemens SIMATIC ET 200SP HA Equipment Manual

Parameters

5.5 HART mapping parameters

Monitoring is effective from an output current of at least 1 mA.
The diagnostics short-circuit applies from a connected load of < 20 Ω. From a load of > 30 Ω the
short-circuit is reported as outgoing again.
5.5 HART mapping parameters
Definition
The HART mapping parameters allow a maximum of 4 HART variables to be configured (mapped)
in the input address space of the I/O module.
If you want to use the maximum of 4 HART variables directly in the input range of the I/O module,
assign these parameters in the properties dialog of the I/O module.
Description
You have the following setting options:
Parameter
Variable 0
:
:
Variable 3
26
Value range
Channel 0...3
Type
• Primary
• Secondary
• Tertiary
• Quaternary
• CiR
Channel 0...3
Type
• Primary
• Secondary
• Tertiary
• Quaternary
• CiR
Default Parameter reassign‐
ment in RUN
0 Yes
CiR Yes
0 Yes
CiR Yes
Equipment Manual, 07/2022, A5E50102497-AB
AQ 4xI HART ISOL HA