Main Board Block-3 - Sony SRS-X88 Service Manual

2-21. MAIN BOARD BLOCK-3

2 Remove the sealing antenna block
in the direction of the arrow.
4 sealing antenna block
1 four screws
(BTTP
M2.6 8)
hole
7 screw
(BTTP M2.6
5 connector
How to install the sleeve ferrite clamp (FC1)
sleeve ferrite clamp (FC1)
3 Draw the antenna wire
out of the hole.
8)
7 three screws
(BTTP M2.6
(CN405)
cushion
guide line
Wrap once.
cushion (core)
6 flexible flat cable (23 core)
(CN015)
8)
7 three screws
(BTTP M2.6 8)
How to install the connector
Insert the connector straight into the interior.
There is a possibility that using this unit without
the connector correctly installed will damage it.
OK
Insert straight into Insert only part way.
the interior.
connector
connector
connector
How to install the flexible flat cable
When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
8 MAIN board block
NG NG
Insert at a slant.
connector
connector connector
NG
Insert at a slant.
flexible flat
cable
colored line
connector
SRS-X88
27