Main Board Block - Sony ZS-S10CP Service Manual

ZS-S10CP
2-4.

MAIN BOARD BLOCK

Note 1: Before disconnecting the fl exible fl at cable (16 core) of optical pick-up block, solder the short-land.
2 four tapping screws
(BV B2.6)
1 connector
(S801)
3 Remove the MAIN board
block in the direction of
an arrow.
6 flexible flat cable
(6 core) (CN808)
Wire e i
2
tape
Note 4: When installing the wire, install to numerical order.
8
7 MAIN board block
– i e er
1
MAIN board
Note 3: When installing the flexible
2 tapping screw
(BV B2.6)
5 flexible flat cable (16 core)
4 Solder the short-land.
Note 2: When assembling the MAIN
cabinet (upper)
i e ie –
MAIN board
flat cable, ensure the coloured
line.
No slanting after insertion.
OK
Insert is straight to the interior.
flexible flat
cable
coloured line
connector
NG
Insert is incline
flexible flat
cable
coloured line
connector
board block, remove the
solder of short-land after
connecting the flexible flat
cable (16 core).