Speaker Wire (L-Ch) - Sony SRS-X88 Service Manual

2-6.

SPEAKER WIRE (L-ch)

Note 1: During reassembly, use new binding band (taiton) to fasten
the wires back in place as they were before disassembly.
ire etti
binding band
tweeter terminal (taiton)
(L-ch)
Note 2: When remove the terminal,
push the protrusion.
Push the protrusion, and remove
the terminal (wide side).
protrusion
Push the protrusion, and remove
the terminal (narrow side).
2 Cut the binding band (taiton).
midrange
terminal
(L-ch)
5 tweeter terminal (L-ch)
(wide) [brown] and [blue]
(See Note 2)
5 tweeter terminal (L-ch)
(narrow) [black] and [black]
(See Note 2)
– Baffle block bottom rear view –
tallatio irectio for t e termi al
OK
curved crease
protrusion
NG
Curved crease is
protrusion
below side.
4 midrange terminal (L-ch)
(wide) [blue] and [yellow]
(See Note 2)
bottom side
ire etti
SRS-X88
ire etti
guide line
center
box filament tape
(LCH) (sub material)
4 midrange terminal (L-ch)
(narrow) [black] and [black]
(See Note 2)
3 Remove the wires
from the clamp.
6 speaker wire (L-ch)
to
CN501
speaker wire
(L-ch)
clamp
13