Sony SRS-X88 Service Manual page 26

SRS-X88
heat sink
(lower)
sleeve ferrite clamp
(FC1)
clamp filter
(ferrite core)
(FC3)
clamp filter
40 mm
(ferrite core)
(FC2)
clamp filter
(ferrite core)
(FC2)
clamp filter
(ferrite core)
(FC3)
Note 2: Bend the wires into an "S" shape, and
then arrange the clamp filter (ferrite core)
(FC3) sideways as shown in the figure.
26
The wires and MAIN board
are touching.
clamp filter
(ferrite core)
(FC2)
MAIN board
clamp
clamp
MAIN board
OK
The wires are suspended
above the MAIN board.
CN100
MAIN board
CN100
MAIN board
Note 1: Arrange the wires along the edge
of the heat sink (lower).
MAIN board
CN508
Note 3: Secure the base
of the wires.
clamp
clamp filter
(ferrite core)
(FC3)
rear cabinet
Note 5: Confirm that the connector
Note 6: Confirm that there is a gap between
the clamp filter (ferrite core) (FC3)
and rear cabinet.
NG
CN100
Note 4: Press the wires against
the MAIN board.
(CN007) is visible.