Speaker Wire (R-Ch), Subwoofer Wire - Sony SRS-X88 Service Manual

SRS-X88
2-5.

SPEAKER WIRE (R-ch), SUBWOOFER WIRE

Note 1: During reassembly, use new binding band (taiton) to fasten
the wires back in place as they were before disassembly.
ire etti
filament tape
(sub material)
3 midrange terminal
4 tweeter terminal (R-ch)
(narrow) [black] and [black]
(See Note 2)
6 subwoofer terminal (narrow)
[black/white]
6 subwoofer terminal (wide)
[white]
12
midrange
binding band
terminal
(taiton)
(R-ch)
tweeter terminal
(R-ch)
3 midrange terminal
(R-ch) (narrow)
[black] and [black]
(See Note 2)
4 tweeter terminal
(R-ch) (wide)
[blue] and [yellow]
(See Note 2)
– Baffle block bottom rear view –
Note 2: When remove the terminal,
push the protrusion.
Push the protrusion, and remove
the terminal (wide side).
Push the protrusion, and remove
the terminal (narrow side).
RC board and
LED board wire
speaker wire
(R-ch)
subwoofer
wire
binding band
(taiton)
2 Cut the binding
band (taiton).
(R-ch) (wide)
[brown] and [blue]
(See Note 2)
2 Cut the binding
band (taiton).
7 subwoofer
CN603
wire
tallatio
protrusion
protrusion
protrusion
bottom side
5 speaker wire (R-ch)
to
to
to
CN099
CN502
irectio for t e termi al
OK
curved crease
NG
Curved crease is
below side.