Tiger CSS Original Instruction Manual page 9

Category Inspection method
Visually check or use
colour dyes to find
cracks
Measure the screw
Sleeve
teeth for wear
Visually check the
adequacy of
installation
Visually check and
measure the degree of
wear.
Visually check or use
colour dyes to find
Spherical cracks at the bottom
Based Cam cam teeth.
Visually check for
broken cam teeth
Inspect each section
for wear.
Measure each section
for wear.
Cam Holder
Inspect each section
for wear.
Collar
Visually check for the
state of attachment.
Measure each section
for wear.
Guide pin
Visually check or
measure for
deformation.
Measure each section
for wear.
Stopper pin Visually check or
measure for
deformation.
Limit of use
When found visually.
When rattling exceeds 2 mm between Screw and Sleeve.
When the Hex. Hole Head Screw is found to be loose or
falls out.
When the degree of wear exceeds 0.5mm.
When found visually.
When any broken tooth is found.
When the clearance between Spherical Based
Cam and Cam Holder exceeds 0.5mm
When the clearance between the Cam Holder, Collar and
Spherical Based Cam exceeds 0.5 mm resulting in
rattling.
When the clearance between Collar, Body, and Cam
Holder exceeds 0.3mm resulting in rattling.
When extreme low head hexagon bolt with hole
disconnects or loosen
When the clearance in the hole exceeds 0.1mm resulting
in rattling.
When bending or deformation exceeds 0.1mm.
When the space with the hole of the Cam Holder exceeds
0.2mm resulting in rattling.
When deformation exceeds 0.2mm.
When the movement of the Spherical Based Cam is not
smooth.
Remedy
Replace
Adjust by tightening
Replace
Replace
Replace
Adjust by tightening
Replace
Replace
www.tigerlifting.com
Page 8 of 14
Instruction Guide Tiger CSS En 202201 v2.0