Table of Contents
Advertisement
Disassembling the unit
1.
Turn the Screw counterclockwise to pull it out of Main Body. (Screw and
Handle cannot be disassembled.)
2.
Loosen Hex. Hole Head Screw, and pull out and remove Spherical Based
Cam, Cam Holder and Collar.
3.
Pull out Guide Pins and Collar.
4.
Pull out two Stopper Pins from Cam Holder and remove Spherical Based
Cam.
5.
Remove Hex. Hole Head Screw and pull out Sleeve.
Assembling the unit
1.
Fit and match the hole of the Sleeve into the body hole of Hex.
Hole Head Screw and fix it.
2.
Place the spherical part of Spherical Based Cam in the Cam
Holder and fix it with two Stopper Pins.
3.
Place the Collar in the Cam Holder, and fit and match the groove
(chase) of the spherical part of Spherical Based Cam, the Guide
Pin hole of Cam Holder and the groove (chase) of the Collar, and
when they are all lined up insert the Guide Pin.
4.
As shown in the figure, assemble and attach the five Disc
Springs (or four for the 6.3t capacity unit).
5.
Put the Steel Ball and Spring in order at the bottom of Cam
Holder.
6.
Place the assembled Spherical Based Cam, Cam Holder, and
Collar in the main body, and fix them with Hex. Hole Head Screw.
7.
Insert and turn Screw into the screw part of the main body.
www.tigerlifting.com
Page 6 of 14
Instruction Guide Tiger CSS En 202201 v2.0
Advertisement
Table of Contents
