Table of Contents
Advertisement
4.
Inner angle for loading of lever hoists or
chain blocks should be less than 30°.
5.
The clamps can be used for lifting pipe
shaped objects and for turning over
material.
Clamps should NOT be used on the following structures
3. Inspection
According to national and international accident prevention and safety regulations, lifting equipment must be inspected:
•
in accordance with the risk assessment of the operating company
•
prior to initial operation
•
before the unit is put into service for any subsequent use
•
after substantial changes
•
however, at least once every 6 months, by a competent person.
The intervals of inspection must be determined by the individual application and are based upon the type of service to which
the clamp will be subjected. In the event of any defects refer the clamp to a Competent Person for thorough examination.
www.tigerlifting.com
Page 5 of 14
Instruction Guide Tiger CSS En 202201 v2.0
Advertisement
Table of Contents
