Table of Contents
Advertisement
Category
Inspection method
Measure for wear, or
deformation.
Steel ball
Visually check if cam
returns automatically
to original position
when moved by hand.
Spring
Visually check the
clearance of spring
coils.
Check for adequate
Disc spring
repulsive power when
cam pushed
4. Maintenance
The equipment should not be dismantled for cleaning or maintenance, except by an authorised competent person. Clean the
clamp. Lubricate any moving parts. Correctly secure all fastenings.
5. Transport, Storage, Decommissioning and Disposal
Transporting the unit:
•
Do not drop or throw the unit, always deposit it carefully.
•
Use suitable transport means. These depend on the local conditions.
Storing or temporarily taking the unit out of service:
To ensure the continuing integrity of the unit you should store the unit in conditions that do not lead to damage or
deterioration. Therefore:
•
Inspect clamps and accessories before placing into storage.
•
Never return damaged clamps to storage.
•
The unit should be secured against unauthorised and unwarranted use.
•
Store the unit in a clean and dry place.
•
Wipe off all dirt and water.
•
A light oil film should be applied to moving parts.
•
Protect the unit including all accessories against contamination, humidity and damage by means of a suitable cover.
•
Protect against corrosion.
•
If the unit is to be used again after it has been taken out of service, it must first be inspected again by a competent
person.
Disposal
When the product comes to the end of its lifecycle, after taking the unit out of service, recycle or dispose of the parts of the
unit respecting local and national environmental regulations.
Limit of use
When any part of Ball diameter becomes smaller than
the size in the table below:
Rated capacity (t)
0.5
Diameter (mm)
4.8
When the movement of the spherical based cam is not
smooth.
When the Cam does not return to its original position
due to the loss of adequate repulsive power from
deformation.
Replace when the spring becomes more than 5% shorter
than its original length.
When normal repulsive power lost from deformation and
lack of movement of Spherical Based Cam.
Remedy
1.0
2.0
3.2
6.3
6.8
6.8
6.8
7.8
Replace
Replace
Replace
www.tigerlifting.com
Page 9 of 14
Instruction Guide Tiger CSS En 202201 v2.0
Advertisement
Table of Contents
