Ryobi R80XZTR42 Manual page 33

NOTE: For best results, the front tip of
the blade should be from 3.1 mm to 9 mm
(1/8 in. to 3/8 in.) lower than the rear tip.
9. If front-to-back adjustment is needed,
turn the adjustment nuts clockwise to
raise or counterclockwise to lower the
back of the cutting deck. Each full turn
of the adjustment nut changes the deck
height approximately 0.32 cm (1/8 in.).
Measure the distance between the blade
and ground again to verify that the front
tip is now 3.1 mm to 9 mm (1/8 in. to 3/8
in.) lower than the rear tip. If not, continue
to adjust and measure until the distance
is correct.
NOTE: Make sure to turn the adjustment
nuts on both sides equally to prevent
throwing the side-to-side measurement
off again.
10. Without moving the adjustment nuts,
retighten the jam nuts on both sides of
the product to secure the adjustment nuts
in place.
11. Without moving the adjustment nuts,
retighten the jam nuts on the front of the
product to secure the adjustment nuts in
place.
12. Lower down the side discharge chute,
and make sure that it is properly closed.
3.2 - 9 mm
9
10
11
12
≠ 3.2 - 9 mm
3.2 - 9 mm
1
2
33
Maintenance