Setting Up The Mail Server; Setting Multiaccess Ip Addresses; Resetting Admin Pc To Its Original Ip Address - Multitech MultiAccess MA220 Quick Start Manual

Setting MultiAccess IP Addresses

1. In the MultiAccess Administration screen, go to the IP Configuration
fields.
2. Fill in the IP information that applies to your MultiAccess unit. The fields
for "IP Address," "Subnet Mask," "Default Gateway" and "Name Server"
are required. A "Secondary Name Server" may be considered optional.
3. Click Update. After the Update button has been clicked, it takes 5
seconds for the page to update.

Resetting Admin PC to Its Original IP Address

In Setting the Admin PC to the network number of the MultiAccess, you
recorded the original IP address of the administrator's PC and then reset it to
the IP address required to allow communication with the MultiAccess unit. You
may now set the IP address of the administrator's PC back to its original value
or to any other value that will allow you to communicate with the MultiAccess at
its new IP address.
Log In Again
Having reset the IP address of the administrator's PC, you must log into the
MultiAccess software again. Enter the MultiAccess's new IP address into your
browser. The Login screen should appear.

Setting Up the Mail Server

1. From the Administration screen, go to the SMTP Configuration fields.
2. Enter the mail server address in the SMTP Server Address window (e.g.,
mail.multitech.com).
3. Enter the SMTP Port (usually 25) that is used by the SMTP Server.
MultiAccess ACS
9