Table of Contents
Advertisement
Safety Recommendations for Rack Instructions
• Ensure proper installation of the MultiAccess in a closed or multi-unit
enclosure by following the recommended installation as defined by the
enclosure manufacturer. Do not place the MultiAccess directly on top of
other equipment or place other equipment directly on top of the MultiAccess.
• When mounting the equipment in a rack, make sure mechanical loading is
even to avoid a hazardous condition, such loading heavy equipment in the
rack evenly. The rack should safely support the combined weight of all
equipment it supports.
• If installing the MultiAccess in a closed or multi-unit enclosure, ensure
adequate airflow within the rack so that the maximum recommended
ambient temperature is not exceeded.
• Ensure that the MultiAccess is properly connected to earth ground via a
grounded power cord. If a power strip is used, ensure that the power strip
provides adequate grounding of the attached apparatus.
• Ensure that the mains supply circuit is capable of handling the load of the
MultiAccess. Refer to the power label on the equipment for load
requirements.
• Maximum ambient temperature for the MultiAccess is 60 degrees Celsius
(140° F).
• This equipment should only be installed by properly qualified service
personnel.
• Only connect like circuits. In other words, connect SELV (Secondary Extra
Low Voltage) circuits to SELV circuits and TN (Telecommunications
Network) circuits to TN circuits.
Hardware Installation (MA420 and MA820 only)
The MultiAccess is designed to install either on a desktop or in a standard EIA
19" rack, and is shipped with the mounting hardware to install the MultiAccess in
the rack. If installing in a rack, use the provided mounting hardware and follow
the rack enclosure manufacturer's instructions to safely and securely mount the
MultiAccess in the rack enclosure. Proceed to the cabling procedure.
MultiAccess ACS
5
Advertisement
Table of Contents
