Parameters - Siemens SIMATIC ET 200SP HA Equipment Manual

Parameters/address space

5.1 Parameters

5.1 Parameters
Introduction
The parameters of the F-DI 16×24VDC HA are described below.
The parameters of the I/O module are displayed in the "Properties" dialog of the module in HW
Config on the following tabs:
• "Parameters" tab
• "Redundancy" tab
This tab is displayed for redundant I/O modules.
• "Time stamp" tab
This tab is used to configure the time stamp for the I/O module.
For more information on time stamping, refer to the function manual "SIMATIC; Process
Control System PCS 7; High-precision Time Stamping with ET 200SP HA
support.industry.siemens.com/cs/ww/en/view/109772337)".
Parameters in the "Parameters" tab
You have the following setting options:
Parameter
F-parameters
F_source_address
F_destination_address
F_monitoring time (ms)
• Cross-channel
Channel activated
Diagnostics: Wire break
Input delay (ms)
20
Value range
1 (display only) *a)
1 to 65534
10 ms to 65535 ms
• Enabled
• Disabled
• Enabled
• Disabled
• 0.4 ms
• 0.8 ms
• 1.6 ms
• 3.2 ms
• 6.4 ms
• 10.0 ms
• 12.8 ms
• 20 ms
The value of the input delay depends
on the time for the short-circuit test
of the sensor and the discrepancy
time.
Default value Parameter
reassign‐
ment in RUN
1 No
Preset No
automatically *b)
2500 No
Enabled No
Disabled No
3.2 ms No
Equipment Manual, 08/2021, A5E45647528-AD
(https://
Scope
Module
Module
Module
All channels
All channels
All channels
F-DI 16x24VDC HA