Napoleon CONTINENTAL CEFB26H Installation And Operation Manual page 19

Turns the heater and blower on/off.
Settings:
H-0 - Heater and blower off
FAN - Blower on
H-1 - Heater on
Heater
NOTE: Heater function can be disabled / enabled by holding the
button for 5s. When the heater function is disabled, "LOC" will be
displayed. The blower has a 10 second delay after the heater is off
to blow out the residual heat.
Sets the timer.
Settings:
30M, 1Hr, 2Hr, 3Hr, 4Hr, 5Hr, 6Hr, 7Hr, 8Hr
Timer
NOTE: The display will read "---" after completing the 9 timer
settings.
Sets desired temperature.
NOTE: When setting is °C or °F, the temperature control is OFF.
Holding the button for 5s will switch the temperature from °C to °F
and vice versa.
Temperature
Control NOTE: The appliance has been programmed with Smart Eco
temperature control. When working under temperature control, the
heater will work with a reduced output if the detected room tem-
perature is close to the setting temperature in order to save energy.
The ECO mode indicating light will turn on in the control panel.
Turns on/off ECO mode manually. The appliance will work with
a reduced heat output in order to save energy. When working
under ECO mode, the ECO mode indicating light will turn on in the
control panel.
ECO Mode
Control
Settings:
ECO - Turn on ECO mode manually
OFF - Turn off ECO mode
Turns on Boost mode manually. The appliance will work with full
heat output and a faster fan speed in order to produce more heat
quickly. When working under Boost mode, the Boost mode indi-
cating light will turn on in the control panel.
Boost Mode
Settings:
Control
BST 10M - Run Boost mode for 10 minutes
BST 20M - Run Boost mode for 20 minutes
BST 30M - Run Boost mode for 30 minutes
OFF - Turn off Boost mode
operating instructions
W415-2971 / C / 11.18.22
EN
19