Renault Arcana User Manual page 216

STOP AND GO ADAPTIVE CRUISE CONTROL
7
6
Switching off the function
The Stop and Go adaptive cruise con-
trol function is deactivated when you
press switch 6.
The warning light  disappears from
the instrument panel to confirm that the
function is no longer active.
Temporary unavailability
The radar is able to detect vehicles
in front of your vehicle. The system
cannot operate correctly if the radar de-
tection area is obscured or if its signal
is disrupted.
2.96
If the radar detection area is obstructed
or the radar signal is disrupted, the
message "Front radar no visibility" is
displayed on the instrument panel and
the Stop and Go adaptive cruise con-
trol is interrupted. The green warning
light  disappears to confirm that the
function has been automatically deac-
tivated.
Ensure that the radar area is kept clean
and is not obstructed by snow, mud, a
badly fitted number plate or any acces-
5
sory fitted at grille level on the front of
the vehicle.
Conditions in certain geographical
areas may hinder the function, for ex-
ample:
– arid zones, tunnels, long bridges or
lightly used roads without road lines,
without signs or trees nearby;
– a military or airport zone.
You must leave such areas in order for
the function to work.
In all cases, if the message is not
erased after the engine is restarted,
please contact an authorised dealer.
(8/14)
Operating faults
If the Stop and Go adaptive cruise con-
trol function operating fault is detected,
the message "Check adaptive Cruise
Control" appears on the instrument
panel and the Stop and Go adaptive
cruise control function is deactivated.
If an operating fault is detected on one
or more components of the system, the
Stop and Go adaptive cruise control
function is interrupted.
©
The
the instrument panel along with, de-
pending on the malfunction, one of the
following messages:
– "Front camera to check";
– "Front radar to check";
– "Check camera/Radar";
– "Check vehicle".
Consult an approved dealer.
warning light appears on