Renault Arcana User Manual page 150

TYRE PRESSURE LOSS WARNING
3
4
7
Resetting procedure
Ignition on, vehicle stopped:
– briefly press the 4 switch as many
times as required to reach the
"Vehicle" tab (or, depending on the
vehicle, the Information page);
– briefly press the 5 or 6 switch to
access the tyre pressures reset
page;
– press and hold the 7 OK switch to
launch the reset.
2.30
(3/4)
The display of the message "If pressure
OK [hold on]" for around five seconds
indicates that the reset request for the
tyre pressure reference value has been
taken into account.
Reinitialisation is carried out after a few
minutes' driving. The "Operation com-
pleted" message indicates that the tyre
pressure reference value has been
5
reset.
Display
The display 3 on the instrument panel
informs you of any tyre pressure faults
6
(flat tyre, punctured tyre, etc.).
"Check tyre press and init."

Warning light comes on, along
with the message "Check tyre press
and init.". They indicate that at least
one tyre is flat or punctured.
In the event of a flat tyre, inflate the rel-
evant tyre.
In the event of a puncture, change the
tyre or consult an authorised dealer.
Check and readjust the pressure of the
four tyres when cold, and launch the
reset of the tyre pressure reference
value.

Warning light goes out after
launching the reinitialisation of the tyre
pressure reference value.
The sudden loss of pressure in a
tyre (burst tyre, etc.) cannot be de-
tected by the system.