Table of Contents
Advertisement
Align the offset at the coupling between electrical machines and the driven
machines so that the maximum permissible vibration values according to ISO
10816 are not exceeded.
3.2.2.1
Mounting and withdrawing output transmission elements
Withdrawing output transmission elements
Mounting output transmission elements
• When mounting output transmission elements (coupling, gear wheel, belt
pulley etc. ) use the thread at the shaft end. If possible, heat up the output
transmission elements as required.
• Use a suitable device when withdrawing output elements.
• When mounting or withdrawing, do not apply any blows, for example with
a hammer or similar tool, to the parts to be mounted or withdrawn.
• Only transfer radial or axial forces specified in the catalog to the motor
bearings via the shaft extension.
88
Advertisement
Table of Contents
