Advertisement
Battery Selection
An alkaline 9-volt battery is recommended.
™
UniPak
Transmitter Battery Installation
1. Slide off the battery cover as shown in Figure E.
2. Insert a 9V battery, observing correct polarity as marked
inside the battery compartment.
3. Replace the battery cover. Set the cover in place on the
transmitter as shown in Figure F, so it rests fully on the
case, then slide it forward firmly until it clicks closed.
Fig. E
Fig. F
Handheld Transmitter Battery Installation
1. While holding the middle of the microphone body normally,
unscrew the battery cover (bottom 3" section) as shown in
Figure G.
2. Insert a 9V battery, observing correct polarity
as marked inside the battery compartment (Fig. H).
3. Replace the battery cover. Do not overtighten.
Fig. G
Fig. H
4
Transmitter Setup
Battery Condition Indicator
After the battery is installed, turn the power on. The battery
condition indicator LED (Fig. I/J) should flash momentarily.
If it does not, the battery is installed incorrectly or it is dead.
If the indicator LED stays on (does not flash), the battery
voltage is low and the battery should be replaced. If this
happens during use, replace the battery immediately to
ensure continued operation.
Fig. I
UniPak Transmitter Input Connection
Connect an audio input device (microphone or guitar cable) to
the audio input connector on the bottom of the transmitter. A
number of Audio-Technica professional microphones and cables
are available separately, pre-terminated with a UniPak input
connector (see "Optional System Accessories" on page 6).
Input
Connector
Battery
Condition
Indicator
Power Switch
Power Switch
(Off/Standby/On)
(Off/Standby/On)
Fig. J
Battery Condition
Indicator
Advertisement
