Table of Contents
Advertisement
Section 3
BASIC Page – All Configuration Options
Options related to: CONTROLLING ACCESS TO THE CONFIGURATION UTILITY
Field
Configuration
Login Username:
Configuration
Login Password:
NOTE: Once you have logged in, for security reasons you should change the default User Name
and Password. If necessary, the default settings can be reset, either by clicking the Restore
Factory Configuration button at the bottom of the BASIC Page (which will reset all options to
factory defaults), or by using the Reset button on the back of the WA840 (which, as referenced in
Section 1 of this User Guide, will reset only a select number of options).
If you wish, you can disable access control by leaving both the Configuration Login Username
and Configuration Login Password blank, but this is not recommended.
Remote Login
Port:
(ADVANCED)
Options related to: ENABLING PRIMARY ACCESS POINT FUNCTIONS
Field
Operation Mode:
(ADVANCED)
3-6
Sets your user name to access this Web-based Configuration Utility.
admin
FACTORY DEFAULT:
Sets your password to access this Web-based Configuration Utility.
motorola
FACTORY DEFAULT:
Enables access to the Web-based Configuration Utility while away
from your home or office, through your broadband connection. An
HTTP port (such as 8080) must be provided to enable remote
access. Leave this field blank to disable remote access.
(blank)
FACTORY DEFAULT:
Enables the wireless-only broadband router functions of the WA840
(the physical port labeled "LAN" becomes the interface to your
broadband modem, or WAN interface). These router functions
include:
•
Routing data in your local network using IP addresses of the
connected devices, allowing the IP address for your
broadband connection to be shared among those devices.
This is called Network Address Translation (NAT).
Description
Description
Configuration
(continued on next page)
WA840
Advertisement
Table of Contents
Troubleshooting
