Table of Contents
Advertisement
Section 1
LED Description
The underlined items represent network activity.
LED
Condition
1 Power
ON
ON
OFF
2 Wireless
OFF
ON/Blinking
3 Device
ON/Blinking
ON/Blinking
OFF
1-10
Color
Status
Green
The device is powered on and operating normally.
Red
The Power LED turns
button is depressed. If the reset button is held down,
the LED starts to blink
username, password, private LAN IP address,
private subnet mask address and operation mode
are restored to factory default settings.
If the Power LED stays
seconds, this indicates that the firmware is corrupted
and needs to be restored.
None
The device is not powered on.
None
The wireless interface is not enabled by the
firmware.
Green
The wireless interface is enabled / active traffic
present.
NOTE: The wireless LED does not blink on WA840G
"Version 1" hardware. You can determine your
version of hardware by looking at the product
label on the bottom of the access point. Within
the box that includes the FCC logo, a "Version 1"
unit will display "MODEL: WA840G", while a
"Version 2" unit will display "MODEL:
WA840Gv2" (see example below).
Amber
10BaseT link detected/active traffic present.
Green
100BaseT link detected/active traffic present.
None
No external Ethernet device has been attached and
detected. The Ethernet link is down.
Overview
RED
as soon as the reset
RED,
and the access point's
RED
for longer than 5
WA840
Advertisement
Table of Contents
Troubleshooting
