Installation
2
Click the Print icon or choose Print from the File menu to display the Print dialog box.
In both the Pages from and to fields, enter the page number on which the Wall
Mounting Template appears.
Be sure you print the template at 100% scale and that Fit to page is not checked in the
Print dialog box.
3
Click OK.
4
Measure the printed template with a ruler to ensure that it is the correct size.
5
Use a center punch to mark the center of the holes on the wall.
6
On the wall, locate the marks for the mounting holes you just made.
WARNING!
Before drilling holes, check the structure for potential damage to water, gas, or
electric lines.
7
Drill the holes to a depth of at least 3.8 cm (1½ inches).
8
If necessary, seat an anchor in each hole. Use M5 x 38 mm (#10-16 x 1½ inch) screws
with a flat underside and maximum screw head diameter of 10.5 mm to mount the
access point.
9
Using a screwdriver, turn each screw until part of it protrudes from the wall, as shown:
–
There must be 4.0 mm (.16 inches) between the wall and the underside of the screw
head.
WA840
Section 2
2-5