Fault Indicator - GEM e2 2018 Owner's Manual

FEATURES AND CONTROLS
RIDER INFORMATION CENTER
The rider information center is located in the instrument cluster. All segments will
light up for one second at start-up. If the instrument cluster fails to illuminate, a
battery over-voltage may have occurred and the instrument cluster may have
shut off to protect the electronic speedometer. If this occurs, your dealer can
provide proper diagnosis.
The information center is set to display standard units of measurement and a 12-
hour clock at the factory.
q
Information Display Indicator
w
Drive Mode/Direction Selection
Indicator
e
State of Charge Indicator
INFORMATION DISPLAY
This area will display clock, odometer, trip meter, state of charge (SOC), range
meter, efficiency rate (EFF) or any existing fault codes or warning messages.
See page 31.
MILES/KILOMETERS INDICATOR
The miles or kilometers indicator illuminates to indicate the mode of
measurement selected.

FAULT INDICATOR

When both the chassis fault lamp and the fault indicator (wrench symbol)
illuminate, use the mode button to toggle to VEH FLT on the display, press and
hold the mode button for 3 seconds to access the currently active trouble codes.
Pressing the mode button momentarily will toggle through all current trouble
codes. Your authorized dealer can provide code details and diagnosis.
28
r
Miles/Kilometers Indicator
t
Fault Indicator