Installation - BenQ GV10 User Manual

Installation

The following table describes the items available in the Installation menu:
Item
Projector
Chooses the position in which the projector is installed. See
Position
There are several options to set the image's aspect ratio depending on your input signal source. Options include:
• Auto: Scales an image proportionally to fit the projector's native resolution in its horizontal or vertical width.
Aspect Ratio
• 4:3: Scales an image so that it is displayed in the center of the screen with a 4:3 aspect ratio.
• 16:9: Scales an image so that it is displayed in the center of the screen with a 16:9 aspect ratio.
• Auto Vertical Keystone: Automatically corrects the keystoning at the top/bottom side of the projected image.
Keystone
Setting
• Vertical Keystone Correction: See
Allows you to further configure HDMI settings
• Auto: Automatically selects a suitable color range for the incoming HDMI signal.
HDMI Format
• RGB Full: Utilizes the Full range RGB 0-255.
• RGB Limited: Utilizes the Limited range RGB 16-235.
Eco Mode This setting reduces system noise and power consumption by 30%. If Eco Mode is selected, the light output will be reduced.
We recommend you use the High Altitude Mode when your environment is between 1500 m - 2000 m above sea level, and
ambient temperature is between 0˚C to 30˚C.
Operation under High Altitude Mode may cause a higher decibel operating noise level because of increased fan speed
necessary to improve overall system cooling and performance.
High Altitude
If you use this projector under other extreme conditions excluding the above, it may display auto shut-down symptoms, which is
designed to protect your projector from over-heating. In cases like this, you should switch to High Altitude Mode to solve
Mode
these symptoms. However, this is not to state that this projector can operate under any and all harsh or extreme conditions.
Do not use the High Altitude Mode if your altitude is between 0 m and 1500 m and ambient temperature is between 0˚C to 35˚C. The projector
will be over cooled, if you turn the mode on under such a condition.
Options and descriptions
Choosing a location on page 19
Correcting keystone on page 26
34
for more details.
for more details.