Motorola ASTRO XTS 5000 Basic Service Manual page 87

Disassembly/Reassembly Procedures: Ensuring Radio Submergibility
8.10.4.3 Miscellaneous Hardware
Other items needed for testing the submersible radio include:
• Large water container
• Deionized (DI) water
• A supply of replacement seals, O-rings, and gaskets (refer to the ASTRO XTS 5000 R
exploded view parts list)
8.10.5 Disassembly
Disassemble the radio according to
on page 8-12.
8.10.6 Reassembly
!
C a u t i o n
To reassemble the radio:
1. Remove the main seal O-ring from the casting.
2. Inspect the seal area around the casting for foreign material that might prevent the main seal
O-ring from sealing properly.
3. Install a new main seal O-ring; discard the old O-ring.
4. Reassemble the housing.
!
C a u t i o n
Continue reassembling the radio according to
Tighten all hardware that was loosened or removed.
6881094C28-D
Section "8.8.1 Separate the Casting and Housing Assemblies"
Do not reassemble the radio without first performing the
following preliminary inspection procedure.
The main seal O-ring should not be visible when looking at the
back side of the radio. If the seal is visible, it is improperly
installed.
Section "8.9 Radio Reassembly" on page
8-17
8-14.
July 16, 2004