Brake (S) And Release Rack (S) - Sony DCR-PC350 Service Manual

3-10.Brake (S) and Release Rack (S)

1. Removal procedure
1) Remove the brake (S) 1.
2) Remove the tension spring (release rack (S)) 2.
3) Remove the release rack (S) 3.
Round hole C
3 Release rack (S)
The spring hook
faces downward
2 Extension spring
(Release rack)
Cassette positioning (S)
ULE brake assy
DV MECHANICAL ADJUSTMENT MANUAL VII
2.
1)
2)
3)
1 Brake (S)
Slot B
Dowel A
Extension spring
(Release rack)
(Be careful not to stretch the spring hook.)
Shaft D
— 21 —
Attachment procedure
Remove the release rack (S) 3 by holding it with a ultra
precision tweezers. Install the tension spring (release rack) 2
while being careful of the installation direction of the tension
spring.
Hook the tension spring (release rack) 2 on the hook of the
cassette positioning (S), and then install it in the ULE brake
assy.
Insert the slot B in the dowel A of the release rack (S) 3.
Insert the round hole C into the pivot shaft D and install the
brake (S) 1.
(Installation direction: Claw should be positioned in the reel
table side.)
Key Points in Re-assembling
Cassette positioning (S)
Brake (S)
Claw should be
positioned in the
reel table side.
ULE brake assy
Release rack (S)