Table of Contents
Advertisement
IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
Each IDE channel supports a master device and a slave device. This
motherboard supports UltraDMA. UltraDMA technology provides faster access to
IDE devices. If you install a device which supports UltraDMA, change the
appropriate item on this list to Auto. You may have to install the UltraDMA driver
supplied with this motherboard in order to use an UltraDMA device.
Init Display First
Use this item to define if your graphics adapter is installed in one of the PCI slots.
Power On Function
Hot Key Power ON
The Power On Function item allows you to power on the system by pressing hot-
keys, or typing a password. If you choose Password, you can use the item KB
Power On Password to install a power on password. If you set it to Hot Key, you
can then use the item Hot Key Power On to choose which hot keys are installed.
KBC input clock
This item sets the clock speed for the keyboard controller. Leave this item at the
default value of 8 MHz.
Onboard FDC Controller
Use this item to enable or disable the floppy disk controller that is built into this
mainboard.
Onboard Serial Port 1
This item lets you disable the built-in serial port 1, or enable it by assigning an
I/O address and an Interrupt Request Line (IRQ).
Onboard Serial Port 2
This item lets you disable the built-in serial port 2, or enable it by assigning an
I/O address and an Interrupt Request Line (IRQ).
UR2 Mode
This item defines the operation of serial port 2. In the Normal setting, serial port 2
is assigned to the external COM2 connector. If you have installed an optional
infrared port, you must change the setting of this item to one of the Infrared
settings (usually IrDA or FIR). These settings will disable the external COM2
serial port connector and assign the resources to the infrared device. If you have
selected an IR mode, use the item below, UR2 Duplex Mode to determine if your
IR port operates with half-duplex or full-duplex.
UR2 Duplex Mode
This item lets you set the duplex mode of the infrared port to full or half duplex.
Onboard Parallel Port
This item lets you disable the built-in parallel port, or enable it by assigning an
I/O address and an Interrupt Request Line (IRQ).
56
Default: Auto
Default: Auto
Default: Auto
Default: Auto
Default: PCI Slot
Default: Hot KEY
Default: Ctrl-F12
Default: 8 MHz
Default: Enabled
Default: 3F8/IRQ3
Default: 2F8/IRQ3
Default: Standard
Default: Half
Default: 378/IRQ7
Advertisement
Table of Contents
