Table of Contents
Advertisement
Basic Connections
1
LAN/PoE
Optional Power
Connection
1. Insert one end of an Ethernet cable into the LAN 4/PoE PD port on the device.
2. Insert the other end of the Ethernet cable into the PoE LAN port of your FortiGate
appliance, or to a WAN port of your FortiGate through a power injector. Ensure that the
FortiGate interface provides DHCP server service to issue an IP address to FortiExtender
when connected to LAN Port 4 of FortiExtender.
3. Optionally, if you are not using PoE, connect the device to a power outlet using a
power adapter.
Warning:
You must provide adequate grounding to the PoE injector of the FortiExtender unit, if
required, in compliance with your local electrical code or regulations.
This device complies with IEEE 802.3af/at PoE specification. Do not use a PoE injector
that is not IEEE 802.3af/at compliant as it might damage your device.
12
2
1. Snap off the plastic cosmetic cover between the front LEDs, unscrew the SIM socket dust
cover fastening screw, and then remove the dust cover.
2. Insert your MicroSIM (3FF) SIM card(s) into the SIM socket(s).
3. Observe the following guidelines:
Internet
•
•
4. Insert the SIM card(s) into the SIM socket(s). (Note: For Module 1, make sure that the
cards are facing down with the cut corner on the left; for Module 2, make sure that the
cards are facing up with the cut corner on the right.)
5. Replace the SIM socket dust cover, tighten the dust cover screw, replace the plastic cover,
and then attach the antennas.
Assembly
If installing one SIM card, insert the card into either SIM socket.
If installing two SIM cards, use SIM1 as the primary socket and SIM2 as the
secondary.
13
Advertisement
Table of Contents
