Operation; Turning The Radio On And Off; Channel Selection; Group Selection - Midland 100-Watt UHF User Manual

Titan™ Mobile User's Guide

Operation

Turning the Radio On and Off

Press and hold the power/volume knob for two seconds to turn
the radio on. The radio will perform a power-on test, which
includes lighting all display segments and may sound a single
beep when complete. Under certain circumstances, such as after
the radio has been reprogrammed, it may also display a check
code and sound a triple beep. Rotate the volume knob clockwise
to increase the volume.

Channel Selection

Rotate the channel/menu knob to select the channel. The radio
may be programmed to stop or Rollover when it reaches the
highest and lowest channels. Please consult your dealer or
communications coordinator regarding channels programmed in
your radio.

Group Selection

Your radio channels may be organized into channel groupings
that further sort and organize your channels. To select a different
group of channels, press the channel/menu knob twice, or until
the GRP is displayed, then rotate to the channel/menu knob until
the desired new group number or name is displayed. To exit,
press the channel/menu knob repeatedly until the first channel in
the new group is displayed.
Please consult your dealer or communications coordinator
regarding channel groups programmed in your radio.

Receiving Transmissions from Other Radios

Each channel of your radio may be programmed for carrier
squelch operation, CTCSS/DCS operation or 2-tone operation.
The following paragraphs describe these modes of operation.
Ask your dealer or communications coordinator if you have
questions on how your radio has been programmed to operate.
© 2005, Midland Radio Corporation
13