Using The Scsi Cable - Microtek ArtixScan 120tf Installation And Operation Manual

Using the SCSI Cable

Before connecting the scanner, check to see if your computer system has a built-in
SCSI interface or an installed SCSI card. If you need help on installing the SCSI card,
please refer to the documentation that came with your SCSI card.
Follow the steps below to make a SCSI connection.
1. Shut down your computer.
2. Set the SCSI ID number to 6. If the SCSI ID number 6 is used by another SCSI
3. Connect the scanner to your computer, using the provided SCSI cable.
8 ArtixScan 120tf Installation and Operation Manual
device, check which SCSI ID is free, and set the number to a free SCSI ID from 2
through 5.
Connect one end of the SCSI cable to your computer's SCSI port, and connect the
other end of the cable to the scanner's SCSI port.
For Macintosh users
Push the minus button (-) above the
SCSI ID number to decrease the
number; push the plus button (+) to
increase the number.
6
+